湖南省似大地水准面2017模型及精度分析     

董明旭  李建成  华亮春  姜卫平  尹昊华  敖敏思  曾翔强 《大地测量与地球动力学》2019,39(1):66-71

利用近7万个湖南及邻近省份重力观测数据、502个GNSS/水准控制点及数字高程模型，以EIGEN-6C4全球重力场模型作参考重力场，采用顾及地球曲率影响的各类地形质量位及引力的第二类Helmert凝集法严密算法，利用高分辨率地形数据恢复甚短波扰动重力场，确定空间分辨率2′×2′的高精度湖南省似大地水准面模型（HNGG2017）。经外部检核，模型整体精度均优于±0.022 m。与历史模型相比，新模型在湖南北部常德汉寿、西南部永州江永等地区精度得到显著改善。  相似文献   

激光跟踪仪在核电站主管道安装中的应用     

郭建兵 《北京测绘》2020,(1):123-125

目前,核电站的主管道焊接越来越多的采用了自动焊技术,这有利于提高焊接质量效率,还可以压缩建设成本。然而,主管道自动焊对焊缝的限差较现有工艺要求更高,高精度的测量是实现主管道自动焊的必要条件之一。本文针对主管道自动焊管口组队高精度的技术要求,提出采用激光跟踪仪对主管道自动焊相关的设备进行更为精密的三维工业测量,通过理论技术评定测量精度,然后选择测量仪器和编制具体的测量方案,最终保证了主管道自动焊精确组对的实现。  相似文献   

Experimental Study of a Command Governor Adaptive Depth Controller for an Unmanned Underwater Vehicle     

《Applied Ocean Research》2019

Unmanned Underwater Vehicles (UUVs) are increasingly being used in advanced applications that require them to operate in tandem with human divers and around underwater infrastructure and other vehicles. These applications require precise control of the UUVs which is challenging due to the non-linear and time varying nature of the hydrodynamic forces, presence of external disturbances, uncertainties and unexpected changes that can occur within the UUV’s operating environment. Adaptive control has been identified as a promising solution to achieve desired control within such dynamic environments. Nevertheless, adaptive control in its basic form, such as Model Reference Adaptive Control (MRAC) has a trade-off between the adaptation rate and transient performance. Even though, higher adaptation rates produce better performance they can lead to instabilities and actuator fatigue due to high frequency oscillations in the control signal. Command Governor Adaptive Control (CGAC) is a possible solution to achieve better transient performance at low adaptation rates. In this study CGAC has been experimentally validated for depth control of a UUV, which is a unique challenge due to the unavailability of full state measurement and a greater thrust requirement. These in turn leads to additional noise from state estimation, time-delays from input noise filters, higher energy expenditure and susceptibility to saturation. Experimental results show that CGAC is more robust against noise and time-delays and has lower energy expenditure and thruster saturation. In addition, CGAC offers better tracking, disturbance rejection and tolerance to partial thruster failure compared to the MRAC.  相似文献   

基于噪声随机模型的加权观测融合方法     

黄贤源  隋立芬  范玉茹 《测绘学院学报》2009,(1)

信息融合技术中,在各局部传感器的有色观测噪声为一阶AR模型的情况下,可以利用观测扩增方法消除有色噪声的影响,得到最优加权观测融合方程,从而实现状态的最优滤波解。对于有色观测噪声为MA或ARMA模型的情况,观测扩增方法不再适用。提出了基于有色观测噪声随机模型级数展开的方法,求解出各局部传感器有色观测噪声的方差,并利用该方差对加权观测融合滤波器进行了构造。通过计算实例证明,该方法不仅适用于观测噪声为AR模型,同时适用于噪声MA或ARMA模型。  相似文献   

GEOGRAPHY ON THE PLANETS: GIFT OF REMOTE SENSING*     

Richard J. Pike 《The Professional geographer》1987,39(2):131-145

Extraterrestrial geography has become a reality, as we move from Earth's moon to the planets. A broad-scale regional physiography is being established on twenty planets and satellites through remote sensing techniques. Spacecraft images yield most of the information on Solar System landscapes. Topographic measurements are extracted by monoscopic image-processing, stereophotogrammetry, and radar analysis. Invisible parts of the spectrum furnish non-topographic data.  相似文献   

应用GPS观测青藏高原东北缘应力场变化   总被引：2，自引：0，他引：2  

张永志  胡斌  陈宏宾 《地球科学与环境学报》2003,25(4):80-84

采用各向同性弹性地球模型推导了地面位移场速率与地壳内任意点应力场变化的边界积分关系,同时利用青藏高原东北缘1999～2001年观测的GPS资料对观测区地壳深度为5 km和25 km的主应力和最大剪应力进行了计算分析.结果表明,青藏高原东北缘的主应力变化主要集中在祁连山断裂、海原断裂等,在1920～1954年间历史上发生过多次震级为7.0～8.5级强震的断裂附近,并具有主应力变化沿断层走向分布、最大剪应力沿断层走向交替变化等特征.  相似文献   

滇西动态重力网的分形特征及空间分辨力   总被引：1，自引：1，他引：0  

贾民育 《大地测量与地球动力学》1996,(4)

介绍了用分形学描述地球物理观测网非均匀分布和联合应用分形特征与Ｓｈａｎｎｏｎ定理确定最佳网格距的方法。研究了滇西动态重力网的分形特征，它的分形维Ｄｆ＝１．２７，最佳网格距ｒ０＝２８ｋｍ。讨论了１９８６年至１９９４年间网区发生的８次Ｍｓ＞５．０级地震前重力场变化的可信性，指出这些变化的波长均大于１００ｋｍ，至少２倍于网的最小空间分辨力，因而是可信的  相似文献   

Damage identification method using harmonic excitation force considering both modelling and measurement errors     

Aiko Furukawa  Junji Kiyono  Hirokazu Iemura  Hisanori Otsuka 《地震工程与结构动力学》2005,34(10):1285-1304

A method of structural damage identification using harmonic excitation force is presented. It considers the effects of both measurement and modelling errors in the baseline finite element model. Damage that accompanies changes in structural parameters can be estimated for a damaged structure from the change between measured vibration responses and ones calculated from the analytical model of the intact structure. In practice, modelling errors exist in the analytical model due to material and geometric uncertainties and a reduction in the degrees of freedom as well as measurement errors, making identification difficult. To surmount these problems, bootstrap hypothesis testing, which enables statistical judgment without information about these errors, was introduced. The method was validated by numerical simulation using a three‐dimensional frame structure and real vibration data for a three‐storey steel frame structure. Copyright © 2005 John Wiley & Sons, Ltd.  相似文献   

自动高精度测距系统     

张学庄  张驰 《大地测量与地球动力学》1996,(1)

介绍了自动高精度测距系统。该系统能以５×１０－７的测距精度测定多个观测点的形变，可作为跨断层动态连续观测的新仪器。  相似文献   

冰雹云雷达回波自动识别系统   总被引：2，自引：0，他引：2  

段勇  贺敬安  谈曙青 《成都信息工程学院学报》2001,16(2):110-116

利用CAPPI资料对立体风暴进行识别，计算并提供出实用的风暴结构参数，采用矩心踊跃法和矩不变量法相结合对单体风暴和混合性风暴回波进行跟踪；最小二第线性外推预报；根据WSD－88D的冰雹算法，在风暴结构基础上本文建立了Windows98操作平台上冰雹识别系统，经单站1年11次强对流天气过程的资料检验，结果表明：雹云识别精度达82％。系统建立了大量人机对话框以方便用户，增加实用性及推广性。  相似文献